manual

Terminal ConfiguraTion
113
iso/surCharge properTies
aCCess insTruCTions:
From the Terminal Conguration screen, select the ISO/Surcharge Properties option by pressing <5> on the
keypad.
desCripTion:
The ISO/Surcharge Properties option allows the terminal operator to perform the following functions:
surCharge amounT ConfiguraTion
1. enaBle/disaBle surCharge- Some networks allow a surcharge (or terminal fee) to be imposed on
transactions. If surcharges are in use on your network, you are required to notify the customer of any
additional fee before the transaction is processed. Enabling (checked) surcharge will initiate a surcharge
notication message to be displayed prior to nal processing of the transaction. The customer then has
the option of cancelling the transaction or continuing.
NOTE: If the processor requires a surcharge, you MUST enable (check) this option.
D Press <1> to toggle between enabled (checked) or disabled (unchecked).
2. amounT- This option is the xed-value surcharge amount that will be displayed to the customer in the
surcharge notication message. The surcharge amount that you enter will be displayed to the customer
and must match the actual surcharge rate established by your processor or other applicable regulatory
agencies.
Manually changing the surcharge amount to a higher (or lower) amount does not change the surcharge
collected by the processor. It only changes the surchage amount displayed to the customer and not the
actual fee collected.