manual
Terminal ConfiguraTion
109
2. all CasseTTes loCked/unloCked (nmds only)- The NMDs are designed to physically lock the
cassettes for normal operation. If you need to remove a cassette for servicing, troubleshooting, etc, the
cassettes for the NMDs must rst be unlocked (unchecked). This option Locks (checked) or Unlocks
(unchecked) the cassettes.
NOTE: All options EXCEPT “Cassette Parameters” will display a data entry dialog screen.
D Press <2> to toggle between Locked and Unlocked.
3. reTraCT Cash (nmds only)- This option enables/disables
automatic retraction of the note carriage which transports
notes to the bill chute. When this option is enabled (checked),
the Retract Delay option <4> is activated, allowing you to
specify the length of the delay the dispenser will wait before
retracting the note transporter.
4. enaBle eXTension rejeCTs (rT2000)- On an RT2000
terminal, the TDM dispensers contain a bill extension unit.
This option will enable (checked) or disable (unchecked) the option of rejecting bills in the extension.
enaBle eXTension rejeCTs on: The terminal will stay in service and attempt to purge the extension
before the next dispense for both full and partial dispenses caused by a trailing edge timeout that caused
the machine to stop prior to delivering all of the requested notes.
enaBle eXTension rejeCTs off- The terminal will go out of service with Error Code 97 (Extension exit
trailing edge timeout) for both full and partial dispenses caused by a trailing edge timeout that caused the
machine to stop prior to delivering all of the requested notes.
D Press <3> to toggle between enabled (checked) or disabled (unchecked).
D (For Retract Cash) If enabled, press <4> and enter the delay time. It can be set from 30 to 120
seconds. Press <enTer> when completed.
5. aCTive CasseTTe- This option selects the cassette for setup/changing note conguration parameters or
other media.
D Press <5> repeatedly to cycle through the available cassette(s).
6. CasseTTe in serviCe- Some dispensers (multi-cassette) allow individual cassettes to be placed “Out
of Service” (unchecked). This means the selected cassette(s) will not be used by the dispenser for
withdrawal requests. This capability can be used, for example, to remove a low or empty cassette from
service, while still allowing the dispenser to continue operation using the remaining cassette(s).
NOTE: The NMD-50/100 cassettes MUST be Locked and IN-Service (checked) for normal operation.
D Press <6> to toggle between “In Service” (checked) or “Out of Service” (unchecked).