Installation manual
6
ARGO Installation Manual
AC power for the terminal should come from a
dedicated source with an isolated ground.
e ATM AC power feed will
be a dedicated line, to which no other electrical devices
are connected. e ATM power line will be wired for
a single duplex-style outlet and connected directly to
the AC service panel. (No extension cords)
An equipment grounding
conductor that is insulated from the conduit or raceway
and all other grounding points throughout its entire
length. e only points of electrical connection will be
at the duplex outlet and service panel ends of the line.
e telephone line servicing
the ATM will not be a party line or any other
shared type connection (fax machines, Point of
Sale devices)
e
telephone line be in close proximity to
noisy devices that could induce interference into
the ATM communications channel. See the next
section for additional information on interference
sources.
A clear path of communication
has been set up for interface with Host/Processor.
ere is no security rrewall
that will prevent communication with the Host/
Processor.
TVs
Coolers
Security devices
Neon signs
Devices with compressors or motors.
Dimensions listed comply with US Federal ADA Guidelines. For USA installations, check for additional guid-
ance. For non-USA installations, check regulations relating to the country of install. Dimensions shown in
inches and [millimeters].
eARGOcabinetisoneoftwobasicsizes:deeporshallowcabinet.eshallowcabinetaccomodatesthe
MiniMech dispenser and the deep cabinet accomodates all other dispensers.