Installation manual

19
ARGO Installation Manual
  
   





Anchor bolt installation illustration

Anchor Bolt
. Ensure the mounting location is free of all debris that might cause the
cabinet to not be level. Use blower or vaccuum to remove any dust or
particles.
 Move the ATM into position for mounting by aligning the base over the
four holes drilled in the previous procedure.
 Place an anchor bolt through the cabinet base and into one of the
mounting holes. Use a ball peen hammer to tap the bolt completely into
the hole.
IMPORTANT: If the anchor bolt “falls” into the hole without being
tapped in, the hole is too large! Move the mounting hole pattern and
redrill using smaller holes as necessary to achieve a snug t.
 Place a at washer on the anchor bolt followed by a 1/2” (13mm) nut.
Do not tighten fully, allow for leveling.
 Repeat Steps 3 and 4 for the remaining anchor bolts.