Owner Manual

MEDECO HIGH SECURITY LOCK INSTALLATION

9700, RL1600, RL2000, RL5000, ARGO Hasp part number 03011-02099

1. The lock will be installed in the same manner as the Control Panel. Orient the key in the lock horizon-

tally in the locked position, key on left, teeth facing right.

NOTE: Once the lock body is installed into the door, the stop washer must be repositioned.

2. While holding the key, remove the small nut

and lock washer.

The stop washer should appear as the picture at

the right.

3. Maintain the hold on the key, carefully remove

the stop washer, ﬂ ip it over, and reinstall. It should

appear as the picture at the right.

4. Maintain the hold on the key, install the hasp

onto the end of the lock.

Note the ﬂ ats on the side of the lock and hasp.

Install the hasp pointing down. Representative

installation at right showing the locked position.

Install the lock washer and nut, tighten the nut.

5. Test the movement of the lock before closing

the Fascia. The lock rotates to the LEFT to un-

lock. Ensure the key can be removed in the closed,

locked position only.