Installation manual

16
ARGO G60 INSTALLATION MANUAL
INSTALL STANDARD ANCHORS/
B
OLT ATM TO FLOOR
LOCKING NUT
FLAT WASHER
ARGO ATM BASE
ANCHOR BOLT
MOUNTING NUT
Anchor bolt installation illustration
SLAB
Anchor Bolt
1. Ensure the mounting location is free of all debris that might cause the
cabinet to not be level. Use blower or vaccuum to remove any dust or
particles.
2. Move the ATM into position for mounting by aligning the base over the
four holes drilled in the previous procedure.
3. Place an anchor bolt through the cabinet base and into one of the
mounting holes. Use a ball peen hammer to tap the bolt completely into
the hole.
IMPORTANT: If the anchor bolt “falls” into the hole without being
tapped in, the hole is too large! Move the mounting hole pattern and
redrill using smaller holes as necessary to achieve a snug fi t.
4. Place a fl at washer on the anchor bolt followed by a 1/2” (13mm) nut.
Do not tighten fully, allow for leveling.
5. Repeat Steps 3 and 4 for the remaining anchor bolts.