manual
Triton Systems ©
79
is section of the manual covers preventative maintenance procedures, such as replenishing receipt paper,
cleaning the enclosure, and cleaning the card reader.
**Note**
Only qualied service personnel are authorized to repair or service terminals. Should a malfunction occur, do not
attempt to service the unit yourself. Contact a Triton-certied service provider.
1. Open the rear service door.
2. If paper remains on the roll, cut or tear paper between roll and printer.
3. Remove existing paper and spindle from the paper bracket.
4. Use printer feed button to feed paper through path until all paper comes out of front of the printer.
**Note**
Do not pull receipt paper backward through the printer with the tension roller closed. is may leave paper frag-
ments that can cause paper jams.
5. Pull the printer bracket release handle up and rotate the printer assembly down.
6. Unwind paper and remove the glue tab from roll. Install new paper roll onto spindle.
7. Place paper roll on the paper support bracket by sliding ends of spindle onto bracket.
**Note**
e spindle should be inserted so that paper feeds from top of roll when installed on the paper bracket.
Triton recommends the use of 20# thermal printer paper (Triton P/N 05403-00053) for improved performance
and reliability.
8. Feed paper into the printer take-up slot. Printer will activate and automatically feed the paper through the
printer and slightly out the front of the control panel.
9. If paper does not feed automatically, rotate the printer assembly down again and check the tension lever on the
printer/cutter assembly for correct positioning.
10. Test printer via Management Functions > Diagnostics > Printer > Reset/Test Printer.