manual
Triton Systems ©
76
For your convenience, the video Changing the Combination on an Electronic Lock with Swing Bolt by Triton
Systems/ATMGurus is available on you YouTube.
Caution
Always perform this operation with the door open. Test new/changed combination several times before closing
door. To change the combination, follow the steps below:
**Note**
Aer each key press, the lock will beep. Aer the nal digit is entered, the lock will beep twice. A triple beep
signals an invalid entry. If a mistake is made, wait 30 seconds, then repeat steps 1 - 3.
1. Enter 0-0-0-0-0-0 (six zeros).
2. Enter the current combination. Factory default setting is 1-2-3-4-5-6.
3. Enter the new six-digit combination twice.
4. Test new combination several times with the door open.
e electronic lock has a Wrong Try Penalty lockout feature to prevent unauthorized personnel from accessing
cabinet. is feature performs as follows:
— Entry of four consecutive invalid combinations will start a 5-minute delay period. LED ashes red
at ten-second intervals during delay period.
— At the end of the 5-minute delay period, two more consecutive invalid combinations will begin an-
other 5-minute delay period.
— Lock will continue to produce 5-minute delays until combination is entered correctly.
(if manager code, time delay override, or remote override are programmed)
**Note**
Aer each key press, the lock will beep. Aer the nal digit is entered, the lock will beep twice. A triple beep sig-
nals an invalid entry. Always perform this operation with the door open. If a mistake is made, wait 30 seconds,
then repeat steps.
1. Enter manager code and hold down last digit of code until the lock emits two sets of double beeps.
2. Press 1. Lock should beep twice.
— lock beeps once if a user code is already installed/programmed
— lock beeps twice if function was successful
— lock beeps three times if function was unsuccessful
3. Enter user code twice. e lock will beep twice aer each valid entry of the code.