manual

MANAGEMENT FUNCTIONS
169
*NOTE*
This feature is only available in the
Triton Standard Canadian version of
ATM operating software.
*NOTE*
When using the DATAPAK communications protocol, ensure the termi-
nal’s Primary and Backup Telephone Numbers are configured to dial the
DATAPAK processing organization (NOT the transaction processor!).
FUNCTION: DATAPAK ACCESS CODE
(C
ANADA ONLY)
F
ACTORY DEFAULT: OFF
A
CCESS INSTRUCTIONS:
1.) Select TERMINAL CONFIGURATION from the MANAGEMENT
FUNCTIONS menu.
2.) Select SET TERMINAL PARAMETERS.
3.) Select TELEPHONE.
4.) Select DATAPAK ACCESS CODE.
D
ESCRIPTION:
This function allows you to enter the DATAPAK ACCESS CODE, and to
turn the DATAPAK feature On or OFF. The DATAPAK ACCESS CODE is
provided by the DATAPAK processing organization, and is an identification
number which enables the DATAPAK processing organization to correctly
identify and route data traffic between the terminal and the transaction pro-
cessor.
The current state of the DATAPAK ACCESS CODE feature is shown as either
ON or OFF in the label on the left-hand side of the display. Press the button
next to this label to toggle the state of the feature between ON and OFF.
E
RROR CONDITIONS:
If a DATAPAK-based communications network is being used, the DATAPAK
ACCESS CODE feature must turned ON and the code must be entered cor-
rectly to enable message traffic between the ATM and the processor to take
place.
THIS COMMAND IS USED IN THE:
9100 9110 9700 9705 9710
9750