manual

MANAGEMENT FUNCTIONS
167
FUNCTION: PRIMARY NUMBER
FACTORY DEFAULT: NONE
A
CCESS INSTRUCTIONS:
1.) Select TERMINAL CONFIGU-
RATION from the MANAGE-
MENT FUNCTIONS menu.
2.) Select SET TERMINAL PA-
RAMETERS.
3.) Select TELEPHONE.
4.) Select the PRIMARY NUMBER option.
D
ESCRIPTION:
The Cash Dispenser communicates to your host processor over a dial up
phone line. The phone number of the processor must be entered before live
transactions can be performed.
When this function is selected, the current phone number is displayed (if noth-
ing appears on the screen, no number is set). Select CHANGE to blank the
current entry, and then enter the desired phone number. The phone number
may be up to 30 digits long. It can also contain a dialing prefix, such as a ‘9’
for an outside line, if necessary. If you need to pause after the prefix, place
a comma in the number for a two-second delay at that point. Pressing the
<BLUE> key first, then the <0> key, followed by the <RIGHT ARROW>
key will select the comma character. Make sure to enter the long distance
prefix ‘1’ if you are dialing an 800 number or a toll long distance number.
Do not enter dashes in the number.
E
RROR CONDITIONS:
The Cash Dispenser will not process transactions if the phone number has
not been entered or has been entered incorrectly. In such cases error code
“185 - Phone Number Not Configured”, will be received.
THIS COMMAND IS USED IN THE:
9100 9110 9700 9705 9710
9750