manual

MANAGEMENT FUNCTIONS
139
FUNCTION: SET BILL DIMENSIONS
(9750)
F
ACTORY DEFAULT: COUNTRY-
SPECIFIC
A
CCESS INSTRUCTIONS:
1.) Select TERMINAL CONFIGU-
RATION from the MANAGE-
MENT FUNCTIONS menu.
2.) Select SET TERMINAL PA-
RAMETERS.
3.) Select CASSETTE SETUP.
4.) Choose the CASSETTE PARAMETERS option.
5.) Select a cassette (A, B, C, or D).
6.) Choose SET BILL DIMENSION.
D
ESCRIPTION:
This function lets you to enter the WIDTH and LENGTH measurements
of the item in the specified cassette. The information you enter will be
stored in the cassette, so it is important to ensure that the specified cassette
is present in the mechanism during this operation. If the operation fails, an
error message will be displayed.
When ever cassette data (i.e. Bill Dimension, Cassette ID, or Currency Data)
are changed for a specific cassette, complete the following with the Cash
Dispenser turned ON:
1) Unlock the cassettes if they are not already unlocked.
2) Remove the cassette/s that had the cassette data altered from the Cash
Dispenser.
3) Placed the cassette/s back in the Cash Dispenser to write the new data
to the cassette.
4) Lock the cassettes.
5) Verify that all cassettes are IN SERVICE.
6) Put the Cash Dispenser in operation.
E
RROR CONDITIONS:
Failure to follow the procedure as describe may result in the affected Cassette
be placed Out Of Service for an Error 156. Unlock the Cassette. Remove
it from it feed channel. Then place the Cassette back into its Feed Channel.
Reset the Error to place the Cash dispenser into operation.
THIS COMMAND IS USED IN THE:
9100 9110 9700 9705 9710
9750