manual

MANAGEMENT FUNCTIONS
129
FUNCTION: LOW CURRENCY (9700)
F
ACTORY DEFAULT: ENABLED
A
CCESS INSTRUCTIONS:
1.) Select TERMINAL CONFIGU-
RATION from the MANAGE-
MENT FUNCTIONS menu.
2.) Select SET TERMINAL PA-
RAMETERS.
3.) Select CASSETTE SETUP.
4.) Choose the LOW CURRENCY
option.
D
ESCRIPTION:
This function is used to enable or disable low currency checking on the dispenser
mechanism. If LOW CURRENCY CHECKING is ENABLED, the Cash Dis-
penser will go out of service (it will display an ERROR 182) when the cash
cassette gets down to approximately 60 notes. Enabling LOW CURRENCY
CHECKING will prevent the need for reversals because there will never be a
partial dispense.
If LOW CURRENCY CHECKING is DISABLED, the Cash Dispenser will not
go out of service until the cassette is completely empty. This may result in the
need to reverse the last withdrawal due to a partial dispense occurring. In the
event of a partial dispense, or no dispense, the terminal will automatically inform
the Processor and the customers account will be correctly credited. The record
of the successful reversal will be recorded in the journal record.
E
RROR CONDITIONS:
When the cassette runs out of money during a dispense operation an Error Code
33 (feed failure) will be displayed and the terminal will go out of service. If the
error condition is reset with less than about 1/2” to 3/4” of bills in the cassette an
error code 182 will be displayed (even with LOW CURRENCY CHECKING
disabled). To avoid this the Cash Dispenser must be reset with the cassette out
of the dispenser, or more than 60 bills must be loaded into the cassette.
*NOTE*
If the cassette runs out of currency during a dispense, the terminal will generate another
call to the processor to reverse the amount not dispensed. Do not reset or turn off the
terminal during this call. Doing so will cause the reversal to fail and result in an out
of balance condition.
THIS COMMAND IS USED IN THE:
9100 9110 9700 9705 9710
9750