manual

MODEL 91XX/97XX CONFIGURATION MANUAL
118
FUNCTION: SURCHARGE PERCENT
FACTORY DEFAULT: N/A
A
CCESS INSTRUCTIONS:
1.) Select TERMINAL CONFIGU-
RATION from the MANAGE-
MENT FUNCTIONS menu.
2.) Select SET TERMINAL PA-
RAMETERS.
3.) Choose the SURCHARGE
MODE option.
4.) Select SURCHARGE PERCENT.
D
ESCRIPTION:
The SURCHARGE PERCENT option on the SURCHARGE MODE screen
brings up the PERCENT SETTINGS screen, which enables you to enter a
surcharge percentage amount, as well as choose the LESSER or GREATER
option that is applicable to the surcharge. Remember that these options must
conform to the processor’s requirements or other applicable commerce regu-
lations.
To enter a surcharge percent value press the CHANGE PERCENT AMOUNT
key. The ENTER NEW AMOUNT AND PRESS OK prompt replaces the
CURRENT PERCENT IS: field. Enter the applicable percentage value (from
1 and 99 percent) and press “OK”.
If the processor or other authority requires that the surcharge be the lesser
of either the surcharge amount or surcharge percentage, select the LESSER
option. If the surcharge must be the greater of either the surcharge amount
or surcharge percentage, select the GREATER option.
This value is stored in the terminal and will be displayed to the customer on
the applicable surcharge message screen. The percent settings must be correct
to ensure surcharge messages CUSTOM-G and CUSTOM-H are accurate!
E
RROR CONDITIONS:
If a fixed surcharge amount is to be used (surcharge percent not used) you
must ensure the surcharge comparison option is set to GREATER and the
surcharge percent is set to zero (0). This will ensure that only the fixed sur-
charge amount value will be displayed to the customer. Failure to do so can
cause an incorrect surcharge value to be reported to the customer.
THIS COMMAND IS USED IN THE:
9100 9110 9700 9705 9710
9750