Owner Manual

9600-TO-9650 CONVERSION GUIDE
3
6. Install the Left Side Mounting Bracket (03011-
00078)using a Phillips screwdriver. Repeat the
process for the Right Side Mounting Bracket (03011-
00079).
7. Install the Schock custom slides to the mounting
brackets and dispenser mechanism. ( 03082-00000)
[There are 2 pair of slides. Pull the slides apart.
One slide gets mounted to the mounting bracket,
the other to the dispenser handle bracket (03011-
00104) ]
Slide Mounting Bracket
Slide
Slide
Handle Bracket
5. Disconnect the 2 cables from the E.J. Unbolt the
9600 E.J. from the cabinet and install the 9650 E.J
(09600-02036)
6. Reconnect the E.J. to Backplane data cable. (One
closest to front of cabinet) Remove the 9600 E.J.
to dispenser cable. Connect the 9640/50 E.J to
Dispenser data cable (09600-00057) to the E.J (One
closest to rear of cabinet). Let the other end of
cable rest in cabinet until dispenser is installed.
Dispenser Cable
Bolts
Backplane
cable
Electronic Journal (E.J.)
7. Open the Control Panel. Disconnect all cables
connected to the AC input module located on
the power supply plate. Remove the two screws
(upper left/right) that attach the power supply
assembly to the card cage assembly.
Screws