Owner Manual

6
SPEECH INSTALLATION GUIDE
6. Using a 7/16" nutdriver, remove the bolt shown in Figure 9. Install the ground
wire adapter and secure with bolt previously removed (Figure 10). Connect
the ground wire from the headphone cable to this adapter.
Figure 9. Remove bolt.
Figure 10. Install ground wire adapter.
7. Install an extruded wire harness clip to the speaker screw shown in Figure 11.
Route the cable under and through the clip so cable has a “bow”. Next,
install the adhesive-backed clip between the 2 center-pin torx screws (figure
12). Figure 13 shows the headphone cable routing.
Figure 11. Install clip and
route cable.
Figure 12. Install flat clip and
secure cable.
Figure 13. Cable routing.
Cable routing