Owner Manual

8
MULTIFUNCTION/SPEECH INSTALLATION GUIDE
11. Open the ferrite included in kit. Wrap the headphone cable in the ferrite as
shown in Figure 17. Position the ferrite as close as possible to the headphone
jack and snap ferrite together. Plug the headphone jack into the jack provided
on the Multi-function/Speech module shown in Figure 18.
12. Secure any excess cable to the cable
clip shown in Figure 19.
Figure 17. Install cable in ferrite.
Figure 18. Connect cable to
Multi-function module.
Figure 19. Secure excess cable.
13. Affix the Braille label approximately
1/4" to the right of the headphone
plug as shown in Figure 20. Ensure
correct orientation of label .
Figure 20. Affix Braille label.