Owner Manual

4
MULTIFUNCTION/SPEECH INSTALLATION GUIDE
Installation
Follow these steps to install the speech installation kit for the Model 96XX
ATM:
1. Unlock and open the control panel. Verify that the power switch is in the
OFF (0) position. Close the control panel.
2. Using a tape measure/ruler, mark a point 1- 1/2" from the bottom left edge
shown in Figure 1. From
that mark, measure 1-1/2” down and place another
mark (Figure 2).
This will be the drill point. Erase the previous mark. Figure
3 shows the drill point location.
Figure 3. Drill point location.
Figure 1. Measure 1-1/2" across.
Figure 2. Measure 1-1/2" down.
* Important *
When routing the headphone cables in the control panel, it is critical
that cables are isolated from the main ribbon cable that runs from the
card cage to the keypad. DO NOT ROUTE/SECURE HEADPHONE
CABLE WITH THIS RIBBON CABLE!