Owner Manual

10
MULTIFUNCTION/SPEECH INSTALLATION GUIDE
4. It may be necessary to bend the pins on one or both edges of the chip inward
very slightly to achieve this alignment. To do this, grasp the left and right-
hand edges of the chip and orient the chip so that the pins are facing you
(Figure 3). Place the pins on one side of the chip on a flat surface and apply
mild pressure to bend the pins by angling the top edge of the chip toward
you. Check the alignment of the pins with the socket as before. If necessary,
bend the pins on the opposite edge of the chip.
Figure 3. Rotate chip to bend pins inward.
5. Once the pins of the chip line up with the socket holes, insert the chip into
the socket by applying an even pressure to the chip to seat it firmly in the
socket. Make sure the chip is oriented properly (notch to the left). Make sure
the pins are inserted correctly and that none are bent.
6. Reinstall the memory module into the card cage slot.