Owner Manual

1-3
9600
7. Remove the ribbon cable from between the adhesive
cable clips
8. Disconnect the low paper sensor cable at connector J11
on the printer control board. This cable is connected to
the low paper sensor on the paper roll bracket.
9.
Remove the low paper sensor bracket from
the paper roll bracket. It may be held on with
hex screws or Philips head screws. You may
have one of two types. If you have gure one,
you will have to remove the sensor from the
original bracket and install it onto the new
bracket. If you have gure two, you can reuse
the sensor and bracket combination, and
install it onto the new paper roll bracket. Set
the bracket, sensor, plastic washers, screws,
and cable aside.
Figure 1 Figure 2
6.
Disconnect the cable connectors at J3 (Printer) and
J5 (Printer-Reset) on your applicable keypad adapter
board.