Owner Manual

3-4
Quad Port Board to Multi-function Board uPgrade Procedures
This section covers the application of adhesive cable clips and cable routing in the unit.
1. Remove the covering on a self adhesive cable clip,
and place the clip to the right of the new SPED
adaptor board as shown. Press rmly to ensure good
contact.
2. Route the keypad cable through the clip as shown.
3. Remove the covering on a self adhesive snapping
cable clip and place it to the left of the speaker as
shown. Press rmly to ensure good contact.
4.
Route the EMV Card Reader(Canada only), printer,
blue keypad, and ribbon cables through the clip as
shown, and snap the clip closed to secure.
7 . Connect the blue keypad cable to the PCI-EPP port.
(Canada only: Connect the EMV Card Reader cable
to the Reader port)
5. Remove the covering on
a self adhesive snapping
cable clip and place it to
the front of the upper
cabinet as shown. Press
firmly to ensure good
contact.
6.
Route the EMV Card
Reader(Canada only),
printer, blue keypad, and
ribbon cables through
the new clip, existing
clips, and snap the clip
closed to secure.