Owner Manual

1-10
EMV Card rEadEr UpgradE proCEdUrEs
lOw rECEipt-papEr SEnSOr UpgradE
If you have a type one low paper sensor, you should be here from step 20. If it
looks like the sensor and bracket to the right, you are in the right place.
1. With the sensor and bracket removed from the paper bracket, push the plastic rivets, holding the sensor to the bracket, out
from the sensor side. The handle of a screw driver may be used to push the rivet. It is in 2 (two) parts, much like a lag
bolt. The rivets may break, which is ok, new rivets are provided. Be careful, if the sensor breaks, that’s not ok.
2. Obtain the new sensor bracket.
3. Position the sensor on the new bracket as shown.
4. Using the new plastic rivets provided, attach the sensor
to the bracket. The rivet is inserted through the bracket
into the sensor.
5. Return to Step 20 and attach the sensor and bracket to
the new paper bracket. Don’t forget the plastic washers
between the two brackets, or OMIT the washers if your
paper bracket has shoulders around the mounting holes.