Owner Manual

1-8
EMV Card rEadEr UpgradE proCEdUrEs
29. Insert the new EMV card reader through the front of
the control panel. Ensure the printed circuit board is
on top, as shown.
30. Secure the new EMV card reader with 4 (four) screws
from previous step. (26)
31. Install the grounding strap as shown. Use the open end
wrench for the bolt on the cabinet, and the short Philips
screwdriver for the card cage.
32. Connect a grounding strap to the left corner control
panel hinge bolt (near the card reader).
33. Install the threaded insert: First, locate the panel boss directly below and to the right of the card reader. Ensure there is
no dust, dirt, or other foreign material in the panel boss. Place the insert into the panel boss. Important: position
the insert so the split end is inserted into the boss.
Apply rm pressure with the tip of a Philips screwdriver or other suitable tool to press the insert into the boss. The insert
should t snugly and should be ush with the edge of the boss.