Owner Manual

FIELD CONVERSION PROCEDURE

6. Refer to the Figures below. Remove the DC power supply mounting screw (and ground straps if present)

along the front edge of the power supply case.

7. Slide the DC power supply forward until it stops and then carefully lift it straight up from the top cabinet

enclosure (with attached cables).

INSTALLATION OF THE DUAL POWER SUPPLY

1. Refer to the Figures below. Start the nuts on the two (2) base mounting studs on the power adaptor

bracket. Do not tighten.

2. Mount the dual power supply on the power adaptor bracket. Make sure the guide pins and base studs

on the bracket ﬁ t into the corresponding locations on the backside of the power supply. Make sure the

U-shaped openings on the lower edge of the power supply slip onto the base mounting studs between the

nuts and the bracket.

3. Press down on the dual power supply until the guide pins on the bracket slide all the way up into the cor-

responding slots on the power supply. Tighten the nuts on the base mounting studs.

Slide the single power supply forward and lift it

from the cabinet top enclosure

Location of single power supply mounting

screw

Power Supply mounting screw

Dual power supply mounting points on the power adapter

bracket

Base mounting studs

Guide pins

Mounting points on the backside of the power

supply

Base mounting studs

Guide pins