Owner Manual

MODEL 9100 SPEECH UPGRADE

SPED CABLE REPLACEMENT

1. See figures below. If you currently have a ribbon-type SPED data cable,

this must be replaced. Remove this cable. Connect one end of the multi-

strand data cable (P/N 09120-00630) included in kit. The connection for this

cable is shown in figure.

New data

cable connector

REINSTALL / CONNECT MAIN BOARD PCB

1. Reinstall the Mainboard assembly to the control panel and secure with the

phillips-head screws previously set aside. Route the cables/wires through

the cable routing loop and reconnect to the Mainboard assembly ( including

the audio board ribbon cable and new SPED cable). The figure below shows

the connections for the Mainboard.

Ribbon data cable