Owner Manual

7
MODEL 9100 SPEECH UPGRADE
DRILL / INSTALL SPEECH AUDIO BOARD
1. Locate the “dimpled” area on the control panel front shown in the Figure
below. This area will be drilled out.
2. Center the 5/16" drill bit in this dimple and drill through the panel. You may
want to drill a pilot hole first for centering purposes.
** CAUTION **
Before proceeding, open the control
panel and check /move any cables that
may be in the path of the drill location.
3. Clean/smooth any burrs or rough edges on the inside and back of the hole.
Vacuum or brush any shavings on the inside of control panel.