Owner Manual

MODEL 9100 SPEECH UPGRADE

5. Using the diagonal cutters, cut the Ty-wrap (if applicable) that secures the

dial-up modem module as shown. Discard the Ty-wrap. Remove the modem

module by unseating from its pin holders and set modem aside. Note the

orientation of the modem module before removal!

6. Remove the two (2) screws (and Ty-wrap clip holder, if applicable) that

secure the Mainboard PCB to the back panel. Remove the circuit board (this

will be replaced).

7. Install the Mainboard PCB included in kit and secure with the 2 screws

removed in the previous step. Remember to reinstall the Ty-wrap clip

holder under the upper left screw! If your replaced board did not have a

clip holder, there is one included in kit.

8. Slip the red Ty wrap included through the clip but DO NOT secure at this

time. Reinstall the modem module and secure the Ty-wrap around the module.

Note: Ensure the orientation of the modem module is correct and pins are

seated in the pin holder.

9. Reinstall the front panel over the back panel. Secure Mainboard assembly

with screws removed in step 3. Set Main board assembly aside.