Owner Manual

4
MODEL 9100 SPEECH UPGRADE
Installation
Follow these steps to install the speech installation kit and terminal software for
the Model 9100 ATM:
1. Locate the Main board assembly shown below. Disconnect all the cables/
wires located on each side of this assembly. Note the location/orientation
of the cables before removal.
IMPORTANT: Before installation, unlock and open the control panel. Verify
that the power switch is in the OFF (0) position!
REMOVE / REPLACE MAIN BOARD PCB
2. Remove the phillip-head screws that secure the Main board assembly to
the control panel (Figures below). Set screws aside. Note: There may be a
ground wire attached under the screw for the L-bracket.