Owner Manual

11
MODEL 9100 SPEECH UPGRADE
4. Enter the Erase Program code of 2455. When the erase operation is
completed the main menu will appear.
5. Press the ERASE EEPROM option. A warning screen is displayed, as in
step 3.
6. Enter the Erase EEPROM code of 2455. When the erase operation is
completed the main menu will appear.
7. Press the key next to the DOWNLOAD PROGRAM option. The next screen
will present a message prompting you to connect the PC to the Terminal and
begin the software transfer:
CONNECT THE DOWNLOAD CABLE
1. Connect the 9-pin adapter end of the download cable to the selected serial
port on the PC. Note the serial port you are using (COM1 or COM2 ) for use
in configuring the TriComm for Windows program. See the figures below
for connector location:
** WARNING **
This selection will erase part of the unit’s memory and should be
used only with caution!
Enter the erase code to proceed or cancel to end.
** PROGRAM LOAD **
Connect the PC to the unit or connect phone
line.
Begin the transfer on the PC.