Owner Manual

8
TDM TO MINIMECH CONVERSION PROCEDURES
5. Refer to the Figures below. Remove the DC power supply mounting screw (and ground straps if present) along the front
edge of the power supply case.
6. Slide the DC power supply forward until it stops and then carefully lift it straight up from the top cabinet enclosure (with
attached cables).
INSTALLATION OF THE REPLACEMENT POWER SUPPLY
1. Refer to the Figures below. Start the nuts on the two (2) base mounting studs on the power adaptor bracket. Do not tighten.
2. Mount the power supply on the power adaptor bracket. Make sure the guide pins and base studs on the bracket fi t into the
corresponding locations on the brackets of the power supply. Make sure the U-shaped openings on the lower edge of the
power supply slip onto the base mounting studs between the nuts and the bracket.
3. Press down on the power supply until the guide pins on the bracket slide all the way up into the corresponding slots on the
power supply. Tighten the nuts on the base mounting studs.
Slide the single power supply forward and lift it
from the cabinet top enclosure
Location of single power supply mounting
screw
Power Supply mounting screw
Power supply mounting points
on the power adapter bracket
Base mounting studs
Guide pins
Mounting points on the power supply bracket
Guide pins
Base mounting studs