Owner Manual

7
TDM TO MINIMECH CONVERSION PROCEDURES
REMOVAL OF THE 9100 SINGLE POWER SUPPLY
1. Refer to Figure below. Disconnect the AC line cord and topper (if present) at the DC power supply.
2. Refer to Figures below. Disconnect the DC power cable for the receipt printer from CN1 on the printer controller PCB.
Connect the new printer power cable at the same point.
3. Disconnect the DC power cable for the docking board from J4 on the docking board (inward edge connector of the main-
board). Connect the new docking board power cable at the same point.
4. Disconnect the Dispenser communications cable from the docking board, and remove it from the cabinet.
DC power connection at CN1 on the Printer Con-
troller PCB
Printer DC Power Cable
DC power connection at J4 on the
Docking Board
Dispenser Communication
Cable
Docking Board DC Power
Cable
Disconnecting the 9100 single DC power
supply
AC line cord for Topper
(if present)
AC line cord (from wall)
DC power to dispenser