Owner Manual

3
TDM TO MINIMECH CONVERSION PROCEDURES
PURPOSE
This guide covers the steps for swapping your TDM dispenser in the Model 9100 ATM with a MiniMech
dispenser. This procedure includes a list of all tools and hardware necessary for the conversion as well
as the steps involved. It includes the replacement of the original power supply with an updated version.
SCOPE
This procedure applies to all service personnel involved in the process of maintaining or converting Triton
ATMs. It is to be performed by skilled Triton trained personnel ONLY.
OVERVIEW
The TDM to MiniMech Dispenser Conversion will require the replacement of the TDM dispenser, the
power supply assembly, and all associated hardware and cables. The kit includes all cabling and as-
sociated mounting hardware. The TDM will be replaced with the MiniMech and its associated bracket
assembly. The single power supply will be replaced with an updated power supply and its associated
adapter bracket. Additional primary components of the kit include a 6” AC extension cord, new power
cables for the printer controller and docking boards, as well as the MiniMech and all brackets. It also in-
cludes the addition of an Electronic Journal (EJ), connected between the docking board and the dispenser.
A software upgrade is also required, and included. This instruction manual will cover the replacement of
the TDM with the MiniMech, the replacement of the power supply, and the addition of the EJ.
SAFETY
Adhere to all common safety practices while performing this conversion. After performing the shut down
procedure, ENSURE AC POWER IS DISCONNECTED FROM THE WALL SOURCE.