Owner Manual

TDM TO MINIMECH CONVERSION PROCEDURES

Install the Mounting Bracket and EJ

1. Place the EJ and mounting bracket as shown in the

ﬁ gure. Slide the EJ into the bracket.

2. Mount the EJ and mounting bracket under the right side

of the dispenser bracket as shown. Secure with two (2)

nuts. The EJ connectors are positioned at the top.

Mounting

Screws

3. With the EJ secured, connect the docking board cable

and secure with thumb screws. Connect the EJ to dis-

penser cable and secure. Route the dispenser cable un-

der the dispenser bracket to the back, over the top, and

out the front with the power cable.

EJ to

Dispenser

cable

Power

cable

Docking board connector is on the

left.

Dispenser connector is on the right.