Owner Manual

POWER SUPPLY UPGRADE KIT

FIELD PROCEDURES

(MODEL 9100 ATM)

TDN 07103-00049 03/2007

CORPORATE HEADQUARTERS: RMA (RETURN MATERIAL AUTHORIZATION)

RETURN ADDRESS:

522 E. Railroad Street 21405 Avenue “B”

Long Beach, MS 39560 Long Beach, MS 39560

Phone: (228) 868-1317

Fax: (228) 868-0437

company of Dover Electronics, Inc., a subsidiary of Dover Corporation (NYSE-DOV). DOVER, the DOVER

logo and the family of marks and TRITON, the TRITON logo and the Triton family of marks are registered

trademarks of Delaware Capital Formation, Inc., a wholly owned subsidiary of Dover Corporation.

PAGE 1
POWER SUPPLY UPGRADE KIT FIELD PROCEDURES (MODEL 9100 ATM) TDN 07103-00049 CORPORATE HEADQUARTERS: 522 E. Railroad Street Long Beach, MS 39560 Phone: (228) 868-1317 Fax: (228) 868-0437 03/2007 RMA (RETURN MATERIAL AUTHORIZATION) RETURN ADDRESS: 21405 Avenue “B” Long Beach, MS 39560 COPYRIGHT NOTICE © 2007 Delaware Capital Formation, Inc. All Rights Reserved. Triton Systems of Delaware, Inc. is an operating company of Dover Electronics, Inc., a subsidiary of Dover Corporation (NYSE-DOV).
PAGE 2
POWER SUPPLY UPGRADE PROCEDURES (9100 W/TDMS) PURPOSE This guide covers the steps for upgrading the power supply assembly in the Model 9100 ATM with TDM dispensing mechanisms. This procedure includes a list of all tools and hardware necessary for the conversion as well as the steps involved. SCOPE This procedure applies to all service personnel involved in the process of maintaining or converting Triton ATMs.
PAGE 3
POWER SUPPLY UPGRADE PROCEDURES (9100 W/TDMS) 5. Disconnect the DC power cable from the Main board assembly at jack J4. 6. Disconnect the DC power cable from the Printer Controller board at connector CN1. 7. Disconnect the DC power cable from J12 on the TDM dispenser. 8. Remove the 1/4' hex head screw that secures the power supply and ground wire to the top of the security cabinet. Retain the screw.