Installation guide

ManualsBrandsTriton Systems ManualsOther8100 series

Midtopper Field installation Guide

direct liGhtinG (dc-powered)

Model 81XX/91XX (including X2)/97XX/Rl16XX

Rl23XX/Rl5XXX (XS/X2/XP) cabinetS

VERSION 5.0

TDN 07102-00043E 02/2009

corporate headquarters:

522 E. Railroad Street

Long Beach, MS 39560

Phone: (228) 868-1317

Fax: (228) 868-0437

Systems of Delaware.

81XX 91XX/RL23XX 97XX/RL5XXX

Summary of content (5 pages)

PAGE 1
Midtopper Field Installation Guide Direct Lighting (DC-Powered) Model 81XX/91XX (including X2)/97XX/RL16XX RL23XX/RL5XXX (XS/X2/XP) Cabinets VERSION 5.0 TDN 07102-00043E 02/2009 81XX 91XX/RL23XX 97XX/RL5XXX Corporate Headquarters: 522 E. Railroad Street Long Beach, MS 39560 Phone: (228) 868-1317 Fax: (228) 868-0437 COPYRIGHT NOTICE © 2008 Triton. All Rights Reserved. TRITON logo is a registered trademark of Triton Systems of Delaware.
PAGE 2
Midtopper Field Installation Guide IMPORTANT NOTICE Triton Systems has discontinued offering a ballast/bulb (AC-powered) for all lighted toppers. The Direct Lighting (DC-powered) Midtopper is a direct replacement for both the ballast/bulb (AC-powered) and LED Light Panel (DC-powered) versions. The Direct Lighting (DC-powered) Midtopper will be the only available option. The Direct Lighting (DC-powered) Midtopper is considered a complete assembly with no serviceable parts.
PAGE 3
Direct Lighting (DC-Powered) Midtopper Installation Procedure These procedures are completed with the terminal AC power OFF. 1. 2. Remove the topper assembly from the shipping container. Locate and remove the dome plugs (if applicable) to uncover the topper power cable access and mounting holes on the top of the ATM cabinet, 3. Unlock and open the ATM control panel. 4. Feed the topper DC power cord through the large access hole in the cabinet.
PAGE 4
Midtopper Field Installation Guide DC Connections Refer to the following notes and figures (as applicable to the model type of the terminal). Plug the DC power cord from the topper (In most cases, an 8-pin molex connector) into any available 8-pin* DC output connector on the power supply. * A 10-pin DC output connector on a power supply is reserved for the dispenser.
PAGE 5
Direct Lighting (DC-Powered) Model 91XX w/TDM or Minimech and a hard-wired single power supply: Locate the power extension cable (splitter) included in the kit. The cable connectors are marked. Disconnect the mainboard power input and connect it to one leg of the extension cable. Refer to the power extension cable (splitter) configuration diagram below. Connect the midtopper DC power cable to the other leg. Reconnect this power cable assembly back to the mainboard.