Instructions / Assembly
Installation & Assembly Instructions
Please contact Customer Service with any questions at:
30700 D Carter Street ∙ Solon, OH 44139 ∙ (P) 440.248.5480 ∙ support@tritonproducts.com
For a full line of products visit www.tritonproducts.com 1
Read all instructions completely before installing. Should you have any questions about your
installation, please call Customer Service at 440-248-5480
Tools needed for this installation (not supplied with kit): Level, Tape Measure, Drill, Drill Bits and Phillips
Head Screwdriver
1. Review Carton Contents: (1 Box Makes Up This Kit)
1 Pc. Pegboard 24" x 48"
36 Pcs. Assortment DuraHook® Locking Pegboard Hooks
38 Pcs. Lock Screws for hooks (short screws packaged separately)
8 Pcs. #12-2" long mounting screws
8 Pcs. #12 plastic wall anchors
8 Pcs. Metal wall mounts/spacers
2. Wall Mounting Instructions:
A. Determine the location where you want to mount your new storage system.
B. Determine if you want to mount board (A.) horizontally or (B.) vertically
C. Using the pegboard, determine the location and height you wish to mount your storage system.
D. (Using diagram 1-1) Hold the sheet of pegboard flat against the wall surface, use level to make
sure board is level and square.
E. (Using diagram 1-1) While still holding pegboard flat against wall level and using a pencil, make a
circular trace inside of all (8) hole locations using diagram 1-1.
F. Using an electric drill with 5/16" drill bit, drill hole locations marked in step (E). Should any hole
location fall in line with a wood wall stud, it will not be necessary to pre-drill.
G. Gently insert plastic wall anchors into holes pre-drilled in step (F.) (You will not need to install
plastic wall anchors where wall studs are located or when installing on solid wood surfaces).
Wall anchors will be required for all concrete walls.
H. Using your pegboard sheet, insert all eight (8) #12- 2" wood screws through the pegboard holes
specified in diagram 1-2.
I. Slip steel wall spacers over each screw from the back of the pegboard as shown in diagram 1-3.
J. Insert each screw into its pre-installed wall anchor or assigned hole location. Using a #2 Phillips
head screwdriver and starting from one of the top corner hole locations insert screws halfway.
(This will leave you enough play/flexibility to insert each screw properly.)
DB-36-Kit |TPB-36-Kit 24”x48” Pegboard, 36 Hooks