Instructions / Assembly

Installation & Assembly Instructions
Please contact Customer Service with any questions at:
30700 D Carter Street ∙ Solon, OH 44139 ∙ (P) 440.248.5480 ∙ [e-mail]
For a full line of products visit www.tritonproducts.com 2
6. Installation of internal center supports (Refer to Figures 1-1 parts call out, 2-1 and 2-4). Center support braces will be
placed inside of angle brackets and run the length of the cart. (figure 2-4) Each center support will be installed with
their flat edges without bolts facing up. From the end of each angle bracket install truss head bolt with center point at
each end. (Repeat for opposite end.)
7. (Figure 2-3) Tighten all (4) top end bolts used to attach corner angle brackets to rail end brackets at both ends.
8. (Figure 2-1) Pull handle installation: Locate the right corner angle bracket with the 4 extra holes at the top. Install pull
handle using ¼” tapered head bolts. (Note: handle will be positioned at end of tool cart that swivel casters will be
installed on.)
9. (Figure 1-2) Installation of Casters: Swivel casters will be installed on the end of tool cart with handle: With cart on its
side insert ¼” truss head bolts through caster mount plate and through holes in bottom tray, install ¼” flat washer and
secure in place using ¼” lock nut. Tighten securely after all 4 bolts have been installed. (Repeat for each caster.)
10. Installation of Louvered Panels: Each 24”x48” panel has pre-drilled mounting holes that line up with the threaded
inserts on cart frame. Insert ¼” Truss bolt into each hole and hand tighten. Once all bolts have been installed on the
cart finish tightening with wrench and Philips head screwdriver.
Secure storage for all parts and fasteners can be achieved using the LocBin plastic Hanging bins.