Installation Manual
Table Of Contents
- List of Figures
- List of Tables
- About This Book
- Warnings and Safety Guidelines
- Avertissements et consignes de sécurité
- Conventions
- Risque de lésions corporelles provoquées par la décharge électrique
- Risque de lésions corporelles provoquées par les câbles à fibres optiques
- Risque de lésions corporelles provoquées par l’exposition de l’énergie radiofréquences
- Autres risques des lésions corporelles
- Risque d’interruption de service
- Autres mises en garde
- Installation Overview
- Staging Procedure
- Installation Procedures
- Commissioning Procedures
- Removing an IFU
- IFU Test Results
- Index
Fast Ethernet Link Performance Test
28 GHz Fast Ethernet IFU Installation (9/17/99) - R0.1 4-11
CONFIDENTIAL & PROPRIETARY
D
O
N
O
T
C
O
P
Y
Fast Ethernet Link Performance Test
This test ensures that the installed IFUs are functional and pass payload traffic
error-free, before the IFUs are added to the network. The Fast Ethernet test set
sends data packets to the near-end IFU. The near-end IFU transmits the data
packets to the far-end IFU, to the Fast Ethernet test set, and back.
To perform the link performance test:
1 Ensure that both the near-end and the far-end IFUs have been aligned.
2 At the near-end site power up the laptop and connect the Ethernet port to
the hub via CAT-5 cable (see Figure 4-4).
Figure 4-4. Fast Ethernet Link Test Setup
FAR-END IFU
NEAR-END IFU
PATCH PANEL
LAPTOP With
SmartApplications
OUTSIDE BUILDING
INSIDE BUILDING
MEDIA
CONVERTER
OUTSIDE BUILDING
INSIDE BUILDING
IFU IFU
HUB
OAM&P
10BaseFL
100BaseFX
SC to SC
SmartBits Test Set
CAT-5
CAT-5
Port 3
Ethernet
Port
MEDIA
CONVERTER
10BaseFL
CAT-5
MT-RJ to SC
ADAPTER
Add-Drop
PATCH PANEL
IFU IFU
OAM&P
Add-Drop
CAT-5
SmartBits Test Set
Port 4
Ethernet
Port
SC to SC
COUPLER
100BaseFX
SC to SC
MT-RJ to SC
ADAPTER
SC to SC
COUPLER
TM
TM
TM