Installation Manual

Aligning the IFU
28 GHz Fast Ethernet IFU Installation (9/17/99) - R0.1 4-5
CONFIDENTIAL & PROPRIETARY
D
O
N
O
T
C
O
P
Y
10 Turn on the multimeter and set it up to measure DC voltage.
11 Connect the RJ-45 plug of the test cable to the laptop.
12 Power up the laptop and access the IFU Link Manager application.
Initialize the IFU if it has not been initialized (refer to IFU Link Manager
online help).
13 Log on to the near-end IFU.
14 Use the IFU Link Manager application to set the near-end IFU radio
transmitter to ON (see IFU Link Manager online help).
15 Ensure that the power control is OFF.
Repeat this procedure for the far-end IFU.
WA RN IN G : Beware! Radio transmitter is ON when the
red light indicator on back side of Invisible Fiber™ unit is
illuminated. Observe all radio frequency energy exposure
and service interruption cautions.
MISE EN GARDE : Attention ! Le poste émetteur est EN
MARCHE lorsque le témoin rouge sur le dos de l’unité
Invisible Fiber
MD
est allumé. Respecter toutes les mises en
garde concernant l’exposition aux radiofréquences et
l’interruption de service.
WA RN IN G – RF EXPOSURE HAZARD: Ensure the
safety of all personnel. Do not stand in front of the
Invisible Fiber™ unit (antenna) in order to avoid possible
harmful radio frequency energy exposure. Serious bodily
injury may result.
MISE EN GARDE – RF EXPOSURE HAZARD :
Assurer la sécurité de tout le personnel. Ne pas rester
debout devant l’unité Invisible Fiber
MD
(l’antenne) afin
d’éviter toute exposition dangereuse aux radiofréquences.
Les lésions corporelles serieux s’ensuivre.