Installation Manual
Table Of Contents
- List of Figures
- List of Tables
- About This Book
- Warnings and Safety Guidelines
- Avertissements et consignes de sécurité
- Conventions
- Risque de lésions corporelles provoquées par la décharge électrique
- Risque de lésions corporelles provoquées par les câbles à fibres optiques
- Risque de lésions corporelles provoquées par l’exposition de l’énergie radiofréquences
- Autres risques des lésions corporelles
- Risque d’interruption de service
- Autres mises en garde
- Installation Overview
- Staging Procedure
- Installation Procedures
- Commissioning Procedures
- Removing an IFU
- IFU Test Results
- Index
28 GHz Fast Ethernet IFU Installation (9/17/99) - R0.1 1-1
CONFIDENTIAL & PROPRIETARY
D
O
N
O
T
C
O
P
Y
1
Installation Overview
This chapter provides an overview of the installation procedure for the
Invisible Fiber™ unit (IFU). In addition, this chapter describes:
n
IFU Link Manager
n
Power source
n
Cables
n
System grounding and surge suppression
Installation Overview
IFUs are loaded with default system attributes at the factory. At the
customer’s designated staging area, the customer-specific attributes,
identified in the site database, are downloaded to the IFU, which is then ready
for installation. At the installation site, the IFU is installed on a mounting
bracket, aligned, and commissioned. When all installation tests are complete
and expected results are achieved on all IFU sites, the network is ready for
customer acceptance.
Site Engineering Folder
Before installing the IFU, the site must be prepared with the appropriate
cables, demarcation box, and any equipment as detailed in the site
engineering folder. (Refer to the Invisible Fiber™ Fast Ethernet Site
Evaluation Guide for details about the contents of the site engineering folder).
The site engineering folder is referenced throughout this document. Photos
and diagrams of the site are included in the folder.