Manual

3
ASSEMBLY
The shotgun is packed in a cardboard box in two sub-assemblies; the action/stock assembly and the forend/barrel
assembly.
Make sure there are no shells in the chamber.
1. Remove all dirt and excess oil from gun, especially from the breech area, also barrel interior and ends.
2. Remove the forearm by pushing the forehand iron catch upwards, this allows the nose of the forearm to release.
With your other hand and at the same time you are pushing the iron catch release upwards, separate the forearm
from the barrel.
3. Lightly oil the already cleaned contact points. Attach barrels to action by grasping the grip of the stock with your
right hand and placing the stock under your right arm. With your right thumb move the opening lever to the right.
Now hold the barrels with your free hand and slide the barrels through the top of the receiver, with the barrel’s nose
pointing down until the hinge notch engages with the hinge pins.
4. Keeping the hinge pin notch engaged with the hinge pin, lift the nose of the barrels until the action closes.
Caution: If you attempt to close the gun and the barrels bind or don’t seem to fit then the hinge pin and notch are
not engaged. DO NOT FORCE, try again. Release the hinge pin and notch and the barrels will be locked in place.
5. Replace the forearm on the gun by sliding the rear of the forearm into the barrel at the same angle by which your
removed it. The round rear of the forearm should match the round front of the receiver. Lift the nose of the forearm
until it engages with the barrels with an audible “click.” If the forearm release latch protrudes after the “click,”
gently push it in place.