Owner`s manual

32 TriSquare Electronics Corporation
5.2.1 PTT Transmitting: To use the headset in the PTT
mode, rst plug the connector into the headset jack on the
side of your eXRS radio, and make sure the VOX/PTT
switch on the cord is in the PTT position. (NOTE: The eXRS
radio’s VOX setting in the radio menu must be in the OFF
setting). Place headset assembly ear hanger over your ear
and position the earbud speaker to a comfortable t which
should position the boom microphone on the side of your
cheek. (The headset can be worn on either ear by removing
the ear hanger by sliding it forward and positioning it on the
other side and sliding it back on) To transmit, simply press the
PTT button on the PTT/VOX Control on the cord and speak in
a normal clear voice. When nished talking, release the PTT
button to receive.
5.2.2 VOX Transmitting: To use the headset in the VOX
mode, plug the connector into the headset jack on the side
of your eXRS radio, and put the VOX/PTT switch on the
cord into the VOX position. (NOTE: The eXRS radio’s VOX
setting in the radio menu must be turned on to one of the 3
VOX sensitivity settings as described earlier in the manual)
Place the headset assembly ear hanger over your ear and
position the earbud speaker to a comfortable t which will
position the boom mic on the side of your cheek. To transmit,
simply speak in a clear normal voice. When nished talking,
the radio will end the transmission and be ready to receive.
6 General Product Care
Your TriSquare eXRS two-way radio will give you years of
trouble-free service if cared for properly. Handle the radio
with care and keep the radio away from dust and water.
When not using your radio or storing it, remove the batteries
and store radios in a dry place. Avoid exposure to extreme
temperatures.
7 Trouble Shooting Issues
Unit does not receive a signal
- Verify that both units are on the same operating
channel.
- Reselect the current channel to re-sync the radios.
- Verify that batteries are new or fully charged.
Unit has poor reception