Owner`s manual

24 TriSquare Electronics Corporation
OFF. Transmitter timeout shall be indicated by a short double
beep as the transmitter is turned off. If no received signal is
present, you may transmit again after releasing the PTT button
and pressing it again.
- To access the TX TIMEOUT TIMER mode menu from the
SETTINGS Menu (Figure 60), scroll until TX TIMEOUT is
highlighted and press OK (Softkey #1). The TX TIMEOUT
Menu will appear as in Figure 61a.
- Use the UP / DOWN (p/q) button to scroll between OFF
and the 4 timeout settings of 30, 60, 90 and 120 seconds.
- Highlight the selection you want and press OK (Softkey #1)
to make that selection and return to the main screen, or press
EXIT (Softkey #2) to return to the Main screen without making
a change.
4.3.4.5 KEY BEEPS
When pressing buttons on the front keypad, a beep sound will
be heard indicating a button has been pressed. This feature
can be turned On or Off. The default setting is ON.
- To access the KEY BEEP menu from the SETTINGS Menu
(Figure 62), scroll until KEY BEEP is highlighted and press OK
(Softkey #1). The KEY BEEP Menu will appear as in Figure 63.
- Use the UP / DOWN (p/q) button to toggle between
BEEP ON and BEEP OFF.
- With your selection highlighted as in Figure 63, press OK
(Softkey #1) to make that selection and return to the main
screen, or press EXIT (Softkey #2) to return to the Main
screen without making a change.
•
Fig. 61b Fig. 61c
TX TIMEOU
T
60 SECONDS
90 SECONDS
OK EXIT
TX TIMEOU
T
120 SECONDS
OFF
OK EXIT
Fig. 60 Fig. 61a
SETTINGS
ROGER BEEP
TX TIMEOUT
OK EXIT
TX TIMEOUT
OFF
30 SECONDS
OK EXIT