User's Manual

These drawings and specifications are the property of
TriSquare Communications and shall not be reproduced or
copied, or used as the basis for the manufacture or sale of
apparatus or devices without permission.
Model No: TSX300
TITLE:
Drawing No: NA
Base
Model:
TSX300
Owner’s Manual Draft
Rev Date: Nov. 07, 2006
3
Compiled By: mworthey Approved by: First Issued: Oct. 12, 2006
File Name: TSX300 Owner's Manual Draft.doc Drawing No: NA
Location: Kansas City
TriSquare Communications Confidential/Proprietary
Page: 3 of 14
TriSquare Communications
Thank you for purchasing the TriSquare TSX300 XRS two-way radio. Your TriSquare XRS radio
is a unique two-way radio and a powerful communications tool that will give you years of trouble-
free service if cared for properly. Read the owners manual carefully before operating the radio.
? Installing Batteries or Rechargeable Battery Pack
To use your new TriSquare XRS radios, you will need to install 3 “AA” batteries, or the optional
NiMH rechargeable battery pack, the TriSquare model TSX-BP. To install batteries and fully
expose the battery compartment door, first swivel the belt clip to the side. To open the battery
compartment door, while holding the radio face down, use your thumbnail to lift upwards (towards
the top of the radio) on the battery compartment tab, and continue to lift the battery compartment
door up and remove. If you are using 3 “AA” batteries, insert the 3 “AA” with the correct polarity as
indicated by the battery diagram on the inside of the battery compartment, matching the positive
(+) and negative (-) terminals of the batteries to the battery diagram. If you are using the optional
TriSquare NiMH rechargeable battery pack TSX-BP, lay battery pack in the battery compartment
with the label side up, and the up arrow pointing towards the top of the radio. Replace the battery
compartment door by sliding the top tabs in first at an angle until it is all the way up, and then
pressing down at the bottom until the battery compartment door locking tab clicks into place
securing the door closed. Replace belt clip if desired.
Initial Radio Setup
? To turn your radio on (after installing batteries per above), press and hold the POWER
On/Off button for 2 seconds. The radio will go through an initialization cycle showing XRS
on the display, sound the power on confirmation tones and power on. Once powered up,
the radio will be in a stand-by mode, ready to transmit or receive a transmission on the
default channel (0000000000, shown as 0 on the display), or ready for you modify or
change features via the MENU button.
Main / Standby Screen
ooo
STANDBY
CH: 0
CONTACTS MENU