User's Manual

Belt Clip
Insert the hook-and-loop strap through the belt clip as shown. Wrap the hook-and-loop
strap around your belt and squeeze the hook portion against the loop section so that the
belt clip is securely fastened to your belt.
Snap the Remote Transceiver onto the belt clip by inserting the swivel connector on the
belt clip into the mounting hole on the back of the Remote Transceiver.
To Remove the Remote Transceiver from the belt clip, push the release latch on the belt
clip.
Battery Replacement:
The Remote Transceiver is equipped with an internal 550mAhr NiMH battery pack that
should supply 2-3 years of use. When the battery reaches the end of its life it should be
replaced with the exact ICOP replacement part. Contact the ICOP Service Department to
obtain a replacement battery.
General specifications
Operating Frequency Range 902 – 928 MHz
Operating Voltage 3.3 to 4.5 VDC
Frequency Hopping Sequences 32,768
Frequencies per Sequence 16
Range 1000 ft
FCC Information:
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS
SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT
CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
An FCC license is not required for operation of this device.