User's Manual

minutes to indicate that two Remote Transceivers are synchronized to the In-Car
Transceiver.
If only one Remote Transceiver unit is found and confirmed, the In-Car Transceiver will
enter programming mode on the special low-power synchronization channel and attempt to
program the current security and channel information into the next Remote Transceiver unit
available in charge mode that it can find. If the programming attempt fails to find a second
Remote Transceiver, the status LED will blink one time every five seconds for three
minutes to indicate that one remote is synchronized to the In-Car Transceiver.
Only two Remote Transceivers can be synchronized to an In-Car Transceiver at one time.
Buttons and Modes of Operation
The Remote Transceiver Wireless Microphone can be switched between three modes of
operation:
1) TRANSMIT Mode
In TRANSMIT mode the Wireless Microphone is fully operational and is transmitting
and receiving continuously. Audio transmitted from the microphone can be recorded
on the DVR. To select TRANSMIT mode, push the record (REC) button on the Remote
Transceiver. Transmit mode can also be selected from the DVR. The Remote
Transceiver will indicate that it is transmitting audio by lighting the Green LED indicator.
The Remote Transceiver will indicate that it has moved out of range of the In-Car
Transceiver by turning off the Green LED and lighting the Yellow LED indicator.
2) HELP Mode
In HELP mode the Wireless Microphone is fully operational and is transmitting and
receiving continuously. In addition, a signal is activated to the DVR to indicate that the
user has pressed the HELP button. To select HELP mode, push the HELP button on
the front of the Remote Transceiver. The LEDs will continuously repeats the pattern
green/red/yellow/red separated by longer periods of green or yellow range status
indication.
After every 7
th
repetition of the green/red/yellow/red pattern, the red LED quickly blinks
1 or 2 times to indicate a low battery during the green or yellow range status indication.
Battery 25% 1 Red Blink
Battery 50% 2 Red Blinks
3) On-STANDBY Mode
In STANDBY mode, the transmitter is turned off and the unit can only receive. Select
STANDBY mode by pushing the record button on the Remote Transceiver while in
TRANSMIT mode or HELP mode. STANDBY cannot be selected from the in-dash unit.
The green LED blinks ON every 6 seconds to indicate RHT is able to transmit and
receive communications. The red LED blinks 1 or 2 times every 6 seconds to indicate
a low battery condition.
Battery 25% 1 Red Blink
Battery 50% 2 Red Blinks
4) OFF
When OFF, the Remote Transceiver cannot transmit or receive. The Remote
Transceiver can be turned OFF by pressing and holding the power button for 1 second