User's Manual

2020RHT
Operating instructions:
The Remote Transceiver has an internal 550 mA hour rechargeable battery pack. Prior to
the first use the battery should be charged for 12 to 15 hours. The Remote Transceiver
can be charged through its charge terminals located on the bottom of the unit while placed
in the In-Car Charger (2020ICC) or the Multiple Office Charger (2020MOC), or through the
external mic/charge jack with the Cigar Plug Charger (2020CPC) or Home Office
Charger(2020HOC).
After the battery is charged, the Remote Transceiver must be synchronized to the In-Car
Transceiver.
To synchronize or resynchronize the In-Car Transceiver to one or two Remote
Transceivers, place the Remote Transceiver unit(s) into the In-Car Chargers or plug into
the Cigar Plug Charger and press the SYNC button on the In-Car Transceiver. The In-Car
Transceiver will first attempt a link confirmation with assigned Remote Transceiver units in
or out of their charging bases. Assigned Remote Transceivers that are not in use should
be turned off or placed in an Office Charger that is out of range of the In-Car Transceiver to
avoid unintentional resynchronization with units not in use.
The In-Car Transceiver status LED will light for the duration of the synchronization and
confirmation operation. If two Remote Transceiver units are found and confirmed, the
process is completed and the status LED will blink two times every five seconds for three
HELP Button
Microphone
RECORD Button
Microphone/Charge Jack
Red LED
Power Button
Green/Yellow LED
Charge Terminals