Manual

82 83
Instructions for use TRISA Hard Floor Cleaner Instructions for use TRISA Hard Floor Cleaner
PROBLEM
SOLUTION
Does not clean well.
Clean the brush roll.
Clean the HEPA lter and waste water tank.
Replace the HEPA lter if it has been in use for a
long time.
Replace the brush roll.
9 Troubleshooting
PROBLEM
SOLUTION
Brush roll not turning.
Make sure the battery is charged. See ‘Charging the
hard oor cleaner’.
Check if the brush roll is jammed. See ‘Cleaning the
brush roll and vacuum tunnels’.
Water is not being dispensed.
Make sure that the water tank is lled. See ‘Filling
the water tank’.
Check if the water nozzle is blocked.
Reduced suction power.
Make sure the battery is charged. See ‘Charging the
hard oor cleaner’.
Check if the waste water tank is full. See 'Emptying
the waste water tank and catch bucket'.
Make sure that the brush roll is correctly installed.
Make sure the pipe tunnel is not clogged.
Water on the air outlet
Check if the HEPA lter is mounted or damp.
Check if the waste water tank is full. See 'Emptying
the waste water tank and catch bucket'.
Unusual noises during use.
Check if the vacuum tunnel is clogged. See ‘Cleaning
the brush roll and vacuum tunnels’.
Unusual noise can occur if the waste water tank is
empty.
Hard oor cleaner not working.
Make sure that the battery is charged and correctly
installed. See ‘Preparing the hard oor cleaner’.
Make sure that the hard oor cleaner is turned on.
Check if the brush roll is clean and correctly installed.
Can’t switch to Max mode.
Check if the battery capacity is below 20%.
NOTICE Max mode is unavailable if the battery
capacity is below 20%.
Trisa_HardFloorCleaner - INDD - Second Draft.indd 82-83Trisa_HardFloorCleaner - INDD - Second Draft.indd 82-83 29-11-2022 01:04:4729-11-2022 01:04:47