Manual
80
81
Instructions for use TRISA Hard Floor Cleaner
Instructions for use TRISA Hard Floor Cleaner
8 Cleaning and maintenance
8.1 Cleaning the hard oor cleaner
1. Clean the hard oor cleaner using a damp cloth.
2. Dry the hard oor cleaner using a cloth.
WARNING! Do not use any solvent based cleaners.
8.2 Cleaning the brush roll and vacuum tunnels
A pipe cleaner is provided with the hard oor cleaner. Use it to clean out any debris from the vacuum tunnel.
1. Remove the waste water tank Ⓧ by pressing the waste release button Ⓘ.
2. Pull on the cover release tab Ⓛ and remove the brush roll cover Ⓟ. ⓳
3. Pinch the brush roll release buttons Ⓜ and remove the brush roll Ⓞ. ⓴
4. Clean the ball bearings and cut away any tangled hair using the provided cleaning brush AA.
21
5. Clean the oor nozzle using a cloth.
22
6. Clean the oor nozzle and vacuum tunnel with the provided pipe cleaning brush Ⓩ .
23
7. Push the brush roll Ⓞ back into the hard oor cleaner until you hear a click.
8. Put the brush roll cover Ⓟ back onto the hard oor cleaner.
24
8.3 Removing the handle
To remove the handle:
25
1. Hold the handle Ⓖ tightly.
2. Pull the handle Ⓖ up while pushing a screwdriver into the hole below the handle Ⓖ.
7.5 Automatic self-cleaning and drying
Entering the self-drying mode ⓱
The hard oor cleaner is equipped with a self-drying mode, capable of drying the brush roll.
To enter the self-drying mode:
1. Put the hard oor cleaner on the charging stand Ⓡ.
2. Press and hold the power button Ⓑ for three seconds.
A symbol shows on the display Ⓔ.
Alternatively, to avoid using self-drying mode:
1. Pinch the brush roll Ⓞ release buttons Ⓜ and remove the brush roll Ⓞ.
2. Put the brush roll Ⓞ in the accessory holder Ⓠ and let the brush roll Ⓞ dry completely.
Entering the self-cleaning mode ⓲
The hard oor cleaner is equipped with a self-cleaning mode, capable of cleaning the brush roll.
To enter the self-cleaning mode:
1. Put the hard oor cleaner on the charging stand Ⓡ.
2. Make sure the water tank Ⓗ is lled, and the battery Ⓙ capacity is above 10%.
3. Press the self-cleaning button Ⓒ.
A symbol shows on the display Ⓔ. The hard oor cleaner dispenses water and turns the brush roll to clean
itself.
After the self-cleaning is completed, the hard oor cleaner starts the self-drying mode
automatically.
Trisa_HardFloorCleaner - INDD - Second Draft.indd 80-81Trisa_HardFloorCleaner - INDD - Second Draft.indd 80-81 29-11-2022 01:04:4729-11-2022 01:04:47
80
81
Instructions for use TRISA Hard Floor Cleaner
Instructions for use TRISA Hard Floor Cleaner
8 Cleaning and maintenance
8.1 Cleaning the hard oor cleaner
1. Clean the hard oor cleaner using a damp cloth.
2. Dry the hard oor cleaner using a cloth.
WARNING! Do not use any solvent based cleaners.
8.2 Cleaning the brush roll and vacuum tunnels
A pipe cleaner is provided with the hard oor cleaner. Use it to clean out any debris from the vacuum tunnel.
1. Remove the waste water tank Ⓧ by pressing the waste release button Ⓘ.
2. Pull on the cover release tab Ⓛ and remove the brush roll cover Ⓟ. ⓳
3. Pinch the brush roll release buttons Ⓜ and remove the brush roll Ⓞ. ⓴
4. Clean the ball bearings and cut away any tangled hair using the provided cleaning brush AA.
21
5. Clean the oor nozzle using a cloth.
22
6. Clean the oor nozzle and vacuum tunnel with the provided pipe cleaning brush Ⓩ .
23
7. Push the brush roll Ⓞ back into the hard oor cleaner until you hear a click.
8. Put the brush roll cover Ⓟ back onto the hard oor cleaner.
24
8.3 Removing the handle
To remove the handle:
25
1. Hold the handle Ⓖ tightly.
2. Pull the handle Ⓖ up while pushing a screwdriver into the hole below the handle Ⓖ.
7.5 Automatic self-cleaning and drying
Entering the self-drying mode ⓱
The hard oor cleaner is equipped with a self-drying mode, capable of drying the brush roll.
To enter the self-drying mode:
1. Put the hard oor cleaner on the charging stand Ⓡ.
2. Press and hold the power button Ⓑ for three seconds.
A symbol shows on the display Ⓔ.
Alternatively, to avoid using self-drying mode:
1. Pinch the brush roll Ⓞ release buttons Ⓜ and remove the brush roll Ⓞ.
2. Put the brush roll Ⓞ in the accessory holder Ⓠ and let the brush roll Ⓞ dry completely.
Entering the self-cleaning mode ⓲
The hard oor cleaner is equipped with a self-cleaning mode, capable of cleaning the brush roll.
To enter the self-cleaning mode:
1. Put the hard oor cleaner on the charging stand Ⓡ.
2. Make sure the water tank Ⓗ is lled, and the battery Ⓙ capacity is above 10%.
3. Press the self-cleaning button Ⓒ.
A symbol shows on the display Ⓔ. The hard oor cleaner dispenses water and turns the brush roll to clean
itself.
After the self-cleaning is completed, the hard oor cleaner starts the self-drying mode
automatically.
Trisa_HardFloorCleaner - INDD - Second Draft.indd 80-81Trisa_HardFloorCleaner - INDD - Second Draft.indd 80-81 29-11-2022 01:04:4729-11-2022 01:04:47
80
Instructions for use TRISA Hard Floor Cleaner
7.5 Automatic self-cleaning and drying
Entering the self-drying mode ⓱
The hard oor cleaner is equipped with a self-drying mode, capable of drying the brush roll.
To enter the self-drying mode:
1. Put the hard oor cleaner on the charging stand Ⓡ.
2. Press and hold the mode button Ⓐ for three seconds.
A
symbol shows on the display Ⓔ.
Alternatively, to avoid using self-drying mode:
1. Pinch the brush roll Ⓞ release buttons Ⓜ and remove the brush roll Ⓞ.
2. Put the brush roll Ⓞ in the accessory holder Ⓠ and let the brush roll Ⓞ dry completely.
Entering the self-cleaning mode ⓲
The hard oor cleaner is equipped with a self-cleaning mode, capable of cleaning the brush roll.
To enter the self-cleaning mode:
1. Put the hard oor cleaner on the charging stand Ⓡ.
2. Make sure the water tank Ⓗ is lled, and the battery Ⓙ capacity is above 10%.
3. Press the self-cleaning button Ⓒ.
A
symbol shows on the display Ⓔ. The hard oor cleaner dispenses water and turns the brush roll to clean
itself.
After the self-cleaning is completed, the hard oor cleaner starts the self-drying mode
automatically.
Trisa_HardFloorCleaner - INDD - Second Draft.indd 80Trisa_HardFloorCleaner - INDD - Second Draft.indd 80 1-12-2022 10:33:501-12-2022 10:33:50