User Manual

1. Remove the VESA Plates

2. Install the Pole and Desk Clamp Assembly

3. Desk Installation

3mm Hex Key

• Use Hex Key to loosen the screws in order to separate the VESA plate from the Adapter Bracket Assembly.

• Retain these screws for later use.

VESA Plate

adjust height

3mm Hex Key

Bottom

Pole

Top

Pole

3mm Hex Key

3mm

Hex Key

3mm Hex Key

tighten

loosen

collar

tighten

3a. Edge Installation

• Determine approximate location

for mount, keeping in mind

display size, height adjustment

and pitch/roll requirements.

• Slip the desk mount assembly

over the edge of desk so that

clamp fully contacts desk edge.

• Turn the knob to adjust the

clamp to edge of desk and

secure it tightly.

Note: If more secure clamping pressure is needed for

thinner desktop surfaces, adjust the clamp adjustment

plate by removing the two screws from the desk clamp

assembly, then align the clamp adjustment plate with

the desk clamp assembly’s upper holes and reattach

using the same screws.

Note: min. desktop thickness=10mm (.4”)

max. desktop thickness=90mm (3.5”)

14-06-217-93337F.indd 4 7/23/2014 4:37:23 PM