Owners manual

Installation

3 - Static IP Address Assignment/Terminal Menu

Configuration Settings

3-1

Determine IP Information: The WEBCARDLX can support a single static IPv4

address (requires setting the IP address, subnet mask and gateway) and/or a

single static IPv6 address. In addition, the WEBCARDLX can support a single

static IPv4 or an IPv6 DNS address that is required to be entered.

3-2

Configure Terminal Emulation Program: If you have not already done so,

download the serial over USB driver (TL-cdc) from the Tripp Lite website. The

driver can be found by going to www.tripplite.com/support and typing

WEBCARDLX in the search field. To install the driver, follow the instructions

provided. Once the driver is installed and a COM port has been assigned, set

your terminal emulation program to use the COM port that corresponds to the

USB port.

3-3

Connect WEBCARDLX to Computer: Connect your PC to the Micro-USB port

on the WEBCARDLX using the cable provided.

3-4

The card will display a Linux-style login after boot up. Login as

localadmin / localadmin to get the standard menu.

Note: User names and passwords are case sensitive.

16-04-234-93358E-EN.indd 6 4/21/2016 3:32:13 PM